cincity
@cincity
Estimable Member
Joined: Feb 9, 2021
Last seen: May 12, 2024
Topics: 20 / Replies: 56
Reply
RE: Look at me - Cinelerra Camera following

@andreapaz It is a bit too technical for me. I will try that out after I have finished the next revision. ATM I'm adding an animated multi-layer ...

1 week ago
Reply
RE: Look at me - Cinelerra Camera following

@andreapaz Is the signal processing (routing) the only difference?

1 week ago
Reply
Answer to: Which histogram?

@andreapaz Thank you! I'm going to try that.

2 weeks ago
Topic
2 weeks ago
Replies: 1
Views: 5
Reply
RE: Move clips with all keyframes

@phylsmith2004 This is enabled in my case. I often have problems that keyframes are changed by keyframes of previous clips. Especially when I h...

2 weeks ago
Reply
Answer to: How did you know Cinelerra GG?

If you ask me Cin is not more difficult than other video editing software. What makes it feel difficult at the beginning is the reversed 1. scrollin...

2 weeks ago
Forum
Reply
RE: My first 4K video and social only

@andreapaz Yes, this is an older 900g drone with no obstacle detection. Though it uses GPS and up to 10 satellites it is unstable especially unde...

2 weeks ago
Topic
Replies: 1
Views: 12
Reply
RE: My first 4K video and social only

@phylsmith2004 These are mostly Classic Vespa (though the number of the new automatics is raising of course). They have a 3 or 4-gear manual and ...

3 weeks ago
Topic
Reply
RE: Howto reduce 50 / 60 Hz pulsing from lights

@igorbeg Yet I have used keyframes for the "given" properties e.g. fade, volume, projector and camera only. Though it is in the documentation I h...

3 weeks ago
Forum
Reply
Answer to: Howto reduce 50 / 60 Hz pulsing from lights

@All Thank you very much for your efforts. @IgorBeg Your edit can equalize the brightness very well. But the frame shift doesn*t look good. ...

3 weeks ago
Forum
Reply
Answer to: Howto reduce 50 / 60 Hz pulsing from lights

Interesting! I wasn't aware this could make a change. Unfortunately the HFR mode of the recorder only is able to bring it down to 25 fps. 25 or 30 F...

3 weeks ago
Forum
Reply
Answer to: Howto reduce 50 / 60 Hz pulsing from lights

Please look here ->/p> What is the "MediaInfo's output of the source file"? The lighting is halogen @ 50Hz surge. This is why I set the r...

3 weeks ago
Forum
Page 1 / 6